Mist eliminator performance can worsen after cleaning if mesh is deformed, segments are reassembled incorrectly, hold-down systems over-compress the pad, deposits remain internally, or cleaning residues alter wetting. Post-maintenance DP and carryover should be compared with the original clean baseline.

When direct mist eliminator liquid-loading data is unavailable, the duty can be screened from upstream droplet generation, separator spacing, drainage rate, operating history, spray conditions, and packed-bed behavior. Estimated and unknown inputs should remain clearly distinguished from measured data.

Boiling and evaporation generate entrained droplets through bubble bursting and vapor flow. Boil-up rate, liquid level, foaming, viscosity, surface tension, concentration, and disengagement space all influence the liquid load reaching the mist eliminator.

Clean a mist eliminator when fouling is reversible and the structure remains sound; repair localized damage when original geometry can be restored; replace the separator when corrosion, permanent deformation, repeated fouling, or process changes make reliable recovery unlikely.

Uneven demister support rings or grids can distort pad thickness, create liquid low points, open segment joints, and cause gas maldistribution. Support levelness, beam deflection, and wet operating load should be checked before installation.