How to Write an Export Packing Specification for Tower Packing and Tower Internals
The word:
Export packing
is often used without defining what it means.
A plastic Pall Ring shipment and a custom stainless-steel distributor do not require the same packaging.
A good export packing specification should match the product.
1. Define the Packaging Objective
Packaging should protect against:
- physical damage;
- contamination;
- moisture where relevant;
- loss of small components;
- handling damage;
- identification loss.
2. Random Plastic Packing
Possible packaging:
- woven bags;
- large bulk bags;
- cartons.
Key concerns include:
- tearing;
- compression;
- contamination;
- UV exposure during storage.
3. Ceramic Random Packing
Packaging should consider:
- impact;
- breakage;
- pallet stability.
Bulk bags may require pallet support depending on project logistics.
4. Metal Random Packing
Protect against:
- crushing;
- deformation;
- contamination.
Packaging should also maintain quantity control.
5. Structured Packing
Custom elements usually require stronger protection.
Possible solutions include:
- crates;
- reinforced frames;
- internal separators;
- segment identification.
The goal is preserving geometry.
6. Tower Internals
Distributors, support grids and demisters may require:
- wooden cases;
- steel frames;
- segmented packing;
- component restraints.
7. Define Package Marking
Labels may include:
- PO;
- project;
- tower;
- bed;
- product;
- material;
- package number;
- gross/net weight.
8. Define Maximum Package Size or Weight
Site handling equipment may impose limits.
If a project cannot handle a 3-tonne crate, the supplier should know before packaging.
9. Protect Small Loose Components
Bolts, clamps and fasteners should be:
- bagged;
- boxed;
- labeled;
- linked to the relevant assembly.
Do not leave them loose inside a large crate.
10. Consider Storage Conditions
If outdoor storage is expected, packaging requirements may need additional protection.
Engineering Takeaway
“Export packing” should be translated into product-specific requirements.
The correct package protects:
Geometry + Material Condition + Identification + Handling + Installation Sequence
without adding unnecessary cost.